How To Setup Wifi On Computer

Positioning The Wireless Router

How to Set Up a Wireless Router

Put your wireless router somewhere where it will receive the strongest signal with the least amount of interference. For better results, follow these tips:

Place your wireless router in a central location. Place the router as close to the center of your home as possible to increase the strength of the wireless signal throughout your home.

Position the wireless router off the floor and away from walls and metal objects, such as metal file cabinets. The fewer physical obstructions between your PC and the router’s signal, the more likely that you’ll be using the router’s full signal strength.

Reduce interference. Some networking equipment uses a 2.4 gigahertz radio frequency. This is the same frequency as most microwaves and many cordless phones. If you turn on the microwave or get a call on a cordless phone, your wireless signal might be temporarily interrupted. You can avoid most of these issues by using a cordless phone with a higher frequency, such as 5.8 GHz.

Set Up Your Modem And Network

Once you have a tried and true internet connection, its time to set up your modem and network.

Go to your modems administration panel by typing the modems IP address into your URL bar. Common modem admin IP addresses include and You can usually find each modems admin IP address on the back of the modem.

Netgear Wifi Mesh Range Extender Ex7300

Youre going to want to match two values between the router you have and the extender you want to buy: the Wi-Fi generation, and the Wi-Fi speed. The generation will generally be either Wi-Fi 5 or Wi-Fi 6 . The speed is expressed as a function of that connection: if the extender is marked as AC750, that means its using 802.11ac at up to 750 megabits per second. If it says AX1800, its using 802.11ax at up to 1800 megabits .

You can buy an extender thats newer and/or faster than your router, and it will work fine. But youll be paying for something that you dont really need, since the extender wont be able to speed up the connection from the router itself.

Also Check: Best Wifi Extenders For Spectrum

Setting Up The Modem And Internet Connection

After you have all the equipment, you’ll need to set up your modem and Internet connection. If your modem wasn’t set up for you by your Internet service provider , follow the instructions that came with your modem to connect it to your PC and the Internet. If you’re using Digital Subscriber Line , connect your modem to a phone jack. If you’re using cable, connect your modem to a cable jack.

Check If Your Computer Has A Wireless Adapter


You should make sure your computer has a wireless network adapter so it can connect to a WiFi network. Usually, a laptop or a tablet has a wireless adapter on it, while a desktop computer doesnt. To know it for sure:

  • Press Win+R to open the Run box. Then type devmgmt.msc and press Enter to open Device Manager.
  • Double click Network adapters to expand this category.
  • Check the list of network adapters for any adapter that has Wi-Fi, wireless, WLANor802.11 in its name. If you find one, that means there is a wireless network adapter on your computer.
  • If there is no wireless network adapter on your computer, you may need to get an USB WiFi adapter for your computer.

    Plug this adapter to your computer, and itll become WiFi capable.

    Also you should make sure your network adapter driver on your computer is up to date so your network connection can work properly.

    If youre not comfortable playing with device drivers, or if your computer cant access the Internet, we recommend using Driver Easy. Its a tool that detects, downloads and installs any driver updates your computer needs.

    To update your drivers with Driver Easy, just click the Scan Now button, then when it lists the drivers you need to update, click Update. The correct drivers will be downloaded, and you can install them either manually through Windows or all automatically with Driver Easy Pro.

    Don’t Miss: Which Southwest Flights Have Wifi

    Use Your Smartphone As A Network Adapter

    Below, well tell you some simple steps that you can follow to have a wireless internet connection on your computer:

    • Grab your smartphone and a USB cable and turn on your computer. Even a charging USB cable will work for this.
    • After your computer is turned on, connect your phone with it using the USB cable. You will hear a recognition sound from your computer and see a notification as well.
    • Turn on wifi on your smartphone.
    • Next, drag down your smartphones notification bar and tap on the USB notification.
    • Select USB tethering from the list of options.
    • Alternatively, you can go to your smartphones settings, connections, and then turn on USB tethering here.
    • Wait for a minute. Eventually, youll see that the wifi bars symbol in your PCs taskbar has changed into a desktop symbol. This means youre connected and ready to surf the web now.

    That was pretty simple, wasnt it? You got a good enough internet connection on your computer and didnt even spend a penny on a wifi adapter.

    What If I Am Unable To Find My Wifi Connection

    Allow us to provide you with a few steps to mitigate some fixes for some common issues with WiFi in your home.

    • Confirm your router is plugged in, and powered on.
    • Make sure that you are within your wireless signal range, try to stay in the same room as your router until you have a connection.
    • Reset the router, and use the default username and password.
    • Try a different wireless channel number.
    • Contact your ISP and verify there are no outages in your area.

    You May Like: Activate Spectrum Net Self Install

    Clean Up Bloatware From Your Computer/pc

    You should know, some software that you dont want always comes preinstalled on most computers and it is known as junkware or crapware.

    Getting rid of bloatware is a necessary step for the PC/computer setup. This is because leaving these apps installed wont do you much good but may slow your computer down.

    The simple way to do this work is downloading an uninstaller like PC Decrapifier to scan the PC for bloatware and wipe it away at a draught or using the built-in tool in Windows.

    Just open Control Panel, click Uninstall a program from the Programs section and get the following window. Then, right-click the software you dont want and choose Uninstall.


    Installing An Pci Wireless Adapter

    How to set up your wireless printer on your computer


    Power off the HP desktop computer and disconnect all of the cables and external devices. Move the computer to a clean work surface.


    Use the Phillips-head screwdriver to remove the retaining screws on the rear of the HP desktop computer that secure the left-side access panel. Alternatively, use your fingers to remove the thumbscrews if the unit has them.


    Attach the metal clip on the end of the anti-static wrist strap to a metal surface inside the HP desktop case. Slide the looped-end of the strap over one of your arms. Touch a metal surface inside the case a few times to discharge any static electricity in your body.


    Locate an empty PCI slot on the motherboard. PCI slots are white, while PCI-X slots are usually black, blue or brown. Remove the screw that secures the slot cover behind the selected PCI slot, and slide the slot cover out of the rear of the computer case.


    Remove the PCI wireless card from its anti-static packaging carefully and avoid touching the gold or silver colored pins on the bottom of the card. Grip the card at the top with both hands and push the pins on the bottom of the card into the PCI slot firmly but gently. Push the card into the PCI slot until it is fully seated.


    Insert the screw you removed from the slot cover into the screw hole on the PCI wireless card slot bracket and tighten it with the Phillips-head screwdriver. Reattach the left-side access panel and secure it with the retaining screws or thumbscrews.






    Read Also: Will Blink Cameras Work Without Wifi

    Connect The Modem To A Phone Jack Or Cable Outlet

    If you have DSL internet, you’ll plug your phone cable into the DSL port, like the image on the left. If you have cable, you’ll plug the coax cable into the “Cable In” or “RF In” jack, like the image on the right.

    Next, connect the modem to your phone jack or cable outlet.

    Which one should you use? It depends on the type of internet service you have:

    • DSL internet plugs into a phone jack with a phone cord.
    • Cable internet plugs into a cable outlet with a coaxial cable.

    But, whether you have cable or DSL, both need to plug into your wall for your internet service to work.

    Think of it like pumping gas into your car. Without gas, your car goes nowhere, just like your computer cant surf online without an internet connection.

    So you connect your car to the gas pump with the nozzlebut without power, the gas pump wont work. You need both a connection to the power grid and a connection to the pump to get gas in your car and drive off into the horizon.

    Likewise, you need a connection to the power grid and a connection to your internet service to binge-watch The Irishman on Netflix or check your email.

    You’re Not In Range Of A Wi

    Don’t discount the possibility that the problem isn’t with your computer, but with the Wi-Fi network. It’s possible the signal is too weak to connect. If you’re using a laptop, move around to see if that helps. Wi-Fi can have trouble going through walls, and so any home or office could have dead zones.

    First, can other devices connect to the Wi-Fi network? If not, then the router might be having its own issues.

    Reboot it by unplugging it for two minutes, then plug it back in and let it restart. If you have a separate internet router, unplug it too, wait a minute, and plug it back in before restarting the Wi-Fi router.

    If you still can’t connect, the issue might be with your internet service provider, so contact the ISP to see if there’s a service outage.

    Also Check: Can You Use 2 Routers In One House

    Connecting Two Computers Wirelessly Using Bluetooth

    While a WiFi network is a great way to connect two computers wirelessly, an alternative is to use Bluetooth to create a connection. While the available range and speeds require both devices to be nearby, Bluetooth has been designed with short-term connections in mind.

    To connect two devices wirelessly using Bluetooth, youll need to make sure that both devices have Bluetooth connectivity. Many modern laptops and PCs come with Bluetooth built-in, but you can use an external USB Bluetooth adapter to make a connection if its missing.

  • To start, make sure that Bluetooth is turned on on the devices youre looking to connect. You can do this on Windows 10 by selecting the action center icon in the bottom-right corner of the taskbar, then selecting the Bluetooth card to the On position.
  • Next, open the Settings menu by right-clicking the Start menu and selecting the Settings option.
  • In the Settings menu, go to the Devices > Bluetooth & other devices menu, then select the Add Bluetooth or other device button.
  • In the Add a device window, select the Bluetooth option.
  • A list of nearby Bluetooth devices will appear in the next menu. Select the other computer you wish to connect with to begin to establish a connection. You may need to authenticate by typing in a PIN code that will be displayed on both screens.
  • Can I Use My Laptop As A Wireless Router

    WiFi Router setup installation Dubai Sharjah **Free Visit**

    Yes, you can! To set up a Mac or Windows laptop as a wireless router, you can use an app that will do it all for you or set it up manually within the operating system. To make your laptop a hotspot, it needs to use your Wi-Fi adapter. Therefore, you cannot access the Internet using the same device. However, you can use a USB Wi-Fi adapter so that you have two Regardless, ethernet is the best option to use if you can, mainly because its faster and more reliable as a source.

    Don’t Miss: Airtime Player App Southwest

    Ethernet Connection Between A Router And Pc

    If you have a wireless device such as a MiFi, but you dont have any wifi hardware for your pc, you can still establish a connection between the two. For this, youll need a router.

    So, if you have a router lying around in the house, you can use it as a repeater which will connect your wireless device to your pc through an ethernet cable.

    You wont have to buy a USB wifi adapter for your pc this way. However, if you dont have a router, buying a wifi adapter will be a much cheaper and simpler solution.

    To use a router as a wifi repeater for a wifi connection in your pc, watch this video tutorial that explains the whole process in detail.

    Disable With Laptop Wi

    Some laptops have an On/Off button or switch for the Wi-Fi device, like the button shown in the picture. It is usually found on the front of the laptop or above the keyboard. Find the button or switch and make sure it is disabled. When disabled, the button should not be illuminated or illuminated as orange or red, or the switch should be in the Off position.

    Don’t Miss: Dunkin Donuts Free Wifi Locations

    Using A Portable Wifi Router

    While a smartphone or tablet can create a quick, temporary mobile network, a better solution for a wider number of devices is to use a portable WiFi router. These have been designed for establishing simple temporary networks while youre away from home, but can also be used in day-to-day usage for two PCs or laptops to connect.

    Devices like the TP-Link WR902AC create a network that any WiFi-capable device can connect to. More advanced routers, like the Huawei E5577Cs-321, also include built-in 4G connectivity, offering a dedicated mobile internet connection for devices that connect to it.

    Most portable routers dont require any setupsimply plug-in and connect. Others come packaged with a mobile app that can allow for quick configuration and device monitoring.

    Can You Connect An Old Computer To Wifi

    How to Set Up Home WiFi Network (Official Dell Tech Support)

    Adding wireless abilities to old desktop pcs is tricky but not impossible. It depends on what version of Windows is installed on it, so if you have Windows XP or anything above, you can try the above-listed methods.

    However, the connection may be too slow to be of any use, so you can, instead, buy a USB adapter, or, you can try installing a PCI express card on your computer.

    None of these methods likely works if you have, for example, Windows ME in your computer, since wifi devices these days dont support this version anymore.

    Recommended Reading: Can You Have Two Internet Routers In One House

    Popular Articles

    Related Stories

    Stay on op - Ge the daily news in your inbox